|
|
|
Discussion Forums
Forum Index
> Rifles general discussion
> CZ 455 Varmint - bedding, do's and dont's
CZ 455 Varmint - bedding, do's and dont's
@ 06:34 pm (GMT) |
Jacob JensenHi all!Just bought a CZ 455 Varmint (17HMR) with a 22LR switchbarrel. I'm planning on bedding the action but would like to hear if you guys have any experience with this particular rifle? - what works as the recoil lug (cant find it) - Should I bed the barrel channel (1 inch)? - should I pillar bed the action first? Thank you and best regards jacob Ps will use MG bedding compund! |
Replies
@ 07:25 pm (GMT) |
Warwick MarflittRe: CZ 455 Varmint - bedding, do's and dont'sHi Jacob. Buy Nathan's books and watch the videos on line. You will find the answers as you gain and increase your knowledge. Good luck with your project. |
@ 07:38 pm (GMT) |
Nathan FosterRe: CZ 455 Varmint - bedding, do's and dont'sHi Jacob, you'll need to use a mixture of plasticine and taping to fill dovetail cuts and pin holes.Yes, do bed into the barrel channel. The recoil interia will be low enough to get by without a recoil lug (though it would be nice if .22's were designed like a normal centerfire). If yours as the same as the stock below, you will have a hard time fitting pillars. Its very annoying when a stock is made in this manner because the stock will want to splay if over torqued. However, if you use a good amount of compound (you'll not the tang will have a massive fill), the job should be very stable. If you need to, you can send me prep photos (or post them here) so I can check the job over and offer help. 
|
|
@ 07:12 am (GMT) |
Jacob JensenRe: CZ 455 Varmint - bedding, do's and dont'sThanks Nathan - just what I nedded!!!@ Warwick: I have all the books, and have watched all the videos - just needed som advice on this specific action :-) Thanks again - i'll post when i start to prep the stock etc... J. |
|
@ 09:13 am (GMT) |
Warwick MarflittRe: CZ 455 Varmint - bedding, do's and dont'sAwesome Jacob. I'm sure that you'll have a good time bedding and end up with a good shooter and gain some skills and knowledge for future projects. well done. |
@ 02:09 pm (GMT) |
Bryan WebsterRe: CZ 455 Varmint - bedding, do's and dont'sFor some specific info on pillar bedding a CZ 455 American here is a link with photos that might clarify things for you:http://www.rimfireshooting.com/index.php?/topic/9518-cz-455-varmint-22-wmr/ |
|
@ 04:36 pm (GMT) |
Jacob JensenRe: CZ 455 Varmint - bedding, do's and dont'sGreat site Bryan....lots of useful information!J. |
Please wait
ABOUT USWe are a small, family run business, based out of Taranaki, New Zealand, who specialize in cartridge research and testing, and rifle accurizing.
|
KNOWLEDGEBASE |
KNOWLEDGEBASE |