Discussion Forums

Peter Bjerregaard

Hi all,
A question regarding original action screws on a k98 action.
One: I have found, I can't use the lock screws since they don't give the right torque. Is this coincidence? Or do others have same problem?
Two: The slot is ~8 mm and ~1 mm wide (old Paul was a metric guy). With parallel sides so the bit has to be



It's hard to find a slotted 8 mm bit now most stop at 6 mm, but I found this after some searching



It fitted front action screw but I had to grind it down a bit to fit rear screw. Strange?

What are you using?

Btw torque screwdrivers are expensive but I found this in a bicycle shop, meant for carbon fibre handlebars etc. 5Nm = 44 inch pounds



Just a tip.

//Peter