Discussion Forums

Michael Kushnerik

I didn't think about buying a bore guide since nathan mentioned they could get in the way when using poly pads, etc.
But I had an idea to use the clear tube that my 1 piece cleaning rod came it.
(This was after i threw it in the garbage, and had to go get it out ha ha)

I cut the clear tube to the length I wanted, then cut the tube in half across the diameter (2 cuts needed).

I used some clamps to keep it rolle
d in place and then taped them together.
It's a bit smaller than the chamber, so you could make it bigger by adjusting the cuts you make in the tube.

It doesn't get in the way of any pads/patches/etc.

Hopefully these pictures come out.



[/img]https://onedrive.live.com/redir?resid=2568BC1DE28C3B0C!1587&authkey=!AH24iya5eTjA-So&v=3&ithint=photo%2cjpghttps://onedrive.live.com/redir?resid=2568BC1DE28C3B0C!1586&authkey=!AMmgRsLUllL9BjA&v=3&ithint=photo%2cjpghttps://onedrive.live.com/redir?resid=2568BC1DE28C3B0C!1585&authkey=!AOjoM57h6LVAafw&v=3&ithint=photo%2cjpg[img]

On another note, my sendero 300wm has extraction problems. It seems ok for 1 shot, then gets tighter. By the 4th shot I need to really hit the bolt to get it to slide back. And, lugs contact is uneven. So, when I send it for trigger recall they can fix that too, i guess?

I was hoping to use it for spring bear season ending on June 15th, then send it in. Any reason I shouldn't do that bc these issues may cause damage?